Eļļa terases dēļiem Livos ALIS Nr. 579-554, tonis OREGONAS PRIEDE, 0.375 litri

Pirkt

14.70 €

Izvēlieties valsti
Pirkt
Cena14.70 €/gab
Pieejamais daudzums
Kods 579-554-0,375
Pielietojums terases dēļiem
Ražotājs Livos
Tonis Oregonas priede
Virsmas efekts matēts
Tilpums 0.375 litri

Informācija

Informācija

Technical information

Application range

For exterior use on timber such as teak, Bangkirai, larch, Douglas fir and cedar. As an initial treatment for wooden terraces, facades and windows.

 

Technical qualities

Impregnated, water repellent, and UV resistant surface.

 

Full declaration

Depending on the color: Isoaliphates, linseed oil - stand oil - natural resin ester, wood oil, micronized wax, mineral pigments, linseed oil, silicic acid, orange oil, dehydrated amino sugar, castor oil - stand oil, linseed oil - wood oil - stand oil, linseed oil - stand oil, pine oil, citron oil, soya lecithin, bentonite, ethanol, chalk, kaolin, dehydrated castor oil, zinc carbonate, natural resin glycerol ester, and drying agents free of lead (Ca, Co, Zn, Zr).

 

Application method

2 ? 3 applications with a brush or roller (see reverse for further information).

 

Coverage

Must be determined by doing a test application.

 

For profiled (fluted) wood:

First coat: 1 liter (1.06 quart) is sufficient for approx. 7 m² (75 ft²), i.e. 140 ml/m².

Second coat: 1 liter (1.06 quart) is sufficient for approx. 35 m² (377 ft²), i.e. 30 ml/m².

 

Total: 1 liter (1.06 quart) is sufficient for approx. 5 m² (53 ft²), i.e. 170 ml/m².

 

For planed wood:

First coat: 1 liter (1.06 quart) is sufficient for approx. 20-25 m² (215-269 ft²), i.e. 40-50 ml/m².

Second coat: 1 liter (1.06 quart) is sufficient for approx. 40-50 m² (430-538 ft²), i.e. 20-25 ml/m².

 

Total: 1 liter (1.06 quart) is sufficient for approx. 13-16 m² (139-172 ft²), i.e. 60-75 ml/m².

 

For cut wood (120-150 grain):

First coat: 1 liter (1.06 quart) is sufficient for approx. 35-50 m² (377-538 ft²), i.e. 20-30 ml/m².

Second coat: 1 liter (1.06 quart) is sufficient for approx. 55-70 m² (529-753 ft²), i.e. 14-18 ml/m².

 

Total: 1 liter (1.06 quart) is sufficient for approx. 20-29 m² (215-312 ft²), i.e. 34-48 ml/m².

 

Drying time

At 23 °C (73 °F) and 50% relative humidity: approximately 5 to 8 hours. The 2nd and 3rd coat can be applied after approximately 18 hours. At higher temperatures, please consider shorter drying times, and by lower temperatures, longer drying times.

 

Cleaning

Clean equipment immediately after use with SVALOS Thinner No. 222 or LEVO Brush Cleaner No. 997.

 

Specific gravity

Approximately 0.87 g/ml.

 

Safety advice

Always make sure, that cleaning cloths, polishing pads, sponges, etc. which are still wet or even slightly moist with ALIS Decking Oil No. 579, to store and then dispose of in an airtight metal container or in water, otherwise there is a danger of spontaneous combustion caused by the plant oil content.

 

Application

Stir thoroughly and remove possible skin formed on surface. Test adhesiveness by doing a test application (beading effects e.g. point to incompatibilities).

Apply with a brush or roller in the direction of the wood grain at temperatures above 10 °C (50 °F), low humidity and dry weather. The applications should be done within 4 weeks.

 

Terraces:

First application sated, e.g. through pouring out and spreading the oil until saturation.

Second application more sparingly. Spread after 5 ? 10 minutes.

 

Windows:

Pre-sand with grain 80 (100) and 120.

First application sated by brush or with a short-hair roller in the direction of the wood grain. Spread excess oil with a brush after 5 ? 10 (20) minutes (depending on the temperature). Intermediate sanding with grain 240.

Second and third application more sparingly. Observe the absorbency of the wood and if a sated application is necessary again, spread with a brush after 5 ? 10 minutes. (A layer formation should be reached after the second coat). Seams of new windows should be wiped immediately after the first application with a lint-free cotton cloth. Silicone should be applied only after complete drying.

 

Facades:

Treat planed wood in such a way, that it is sated. Spread excess oil after approximately 5 ? 20 minutes, depending on the outside temperature. Second and third application according to the instruction for windows.

 

Cleaning

Clean with GLOUROS Cleaner No. 1806 at least once a year.

 

Care

Do after care with ALIS Decking Oil No. 579 when weathering or an extreme loss of gloss becomes visible.

Saistītās preces

Saistītās preces

Uzdot jautājumu

Nosūtīt jautājumu